LCP User Manual. 1 Introduction. Product Overview. LCP makes use of Caton proprietary R2TP protocol, to realize mobile live broadcasting of high efficiency and low ost. It utilizes call IP networks available: 4G, 3G, Wi Fi and Ethernet, - bonding them together to create a high quality uplink for video and audio transmission. Items Supplied • LCP cables with 2 M12 connectors (90° male connector and straight female connector). Cable lengths: 3 m, 5 m, and 10 m (10 ft, 16 ft, 33 ft). See also Table • Blind cover with M12 female connector. • Base plate with D-sub connector and M12 male connector. • Two gaskets and 1 nut for the D-sub connector. • Intermediate cover with the front cover. the LCP The LCP can be used to control the camera when the power to the camera is switched on again. The Monitor output (1) of the LCP now provides a CVBS video signal for use with a monitor with an CVBS input. The mm mini-jack output (4) provides the monitoring audio signal. Note Audio and video monitoring is only available.
The LCp Safe-Weigh® Software System encompasses over 50 years of BLH Nobel application expertise. Plug-n-Weigh® quick calibration and setup procedures save time, money, and even field service calls. Internal diagnostics continuously monitor weigh system performance and alert service personnel to potential problems, before they happen. The manual reset pushbutton provides user control over when the valve can return to the normal operating state. Lockable Pushbutton Covers—Each pushbutton can be locked to prevent unauthorized access to the safety valve operation. Safety Certification—The LCP contribution to failure rates is documented in the DVC SIS safety manual. The LCp Safe-Weigh® Software System encompasses over 50 years of BLH Nobel application expertise. Plug-n-Weigh® quick calibration and setup procedures save time, money, and even ield service calls. Internal diagnostics continuously monitor weigh system performance and alert service personnel to potential problems, before they happen. CONFIGURATION.
The lcp is connected via a cable to the 'plug kit' mounted in one of the inverter cable entries as shown above. 0. 0. This is a manual for the initial setting of REX-C, , -C, -C, -C Do not touch or adjust parts other than those covered in this manual. The LCP draws in the air at the sides at the rear of the server enclosures and Network interface (RJ 45) Ethernet as per IEEE via 10/BaseT.
0コメント